User's Manual

35
User define: Allows user to define PM Timers parameters to control power saving
mode.
Video Off Method
This option allows you to select how the video will be disabled by the power
management. The default is V/H Sync+Blank.
V/H SYNC + Blank: System turns off vertical and horizontal synchronization
port and writes blanks to the video buffer.
DPMS Support: Select this option if your monitor supports the Display
Power Management Signaling (DPMS) standard of the
Video Electronics Standards Association (VESA). Use
the soft-ware supplied for your video subsystem to select
video power management values.
Blank Screen: System only writes blanks to the video buffer.
Video Off In Suspend
Lets you enable the video to power off in suspend mode.
No: Video power off not controlled by power management.
YES:Video powers off after time shown in suspend mode setting.
Suspend Type
Determines CPU status during power saving mode.
Stop Grant: CPU goes into idle mode during power saving mode.
PwrOn suspend: CPU and system remain powered on in suspend mode.
MODEM Use IRQ
Name the interrupt request (IRQ) line assigned to the modem (if any) on your
system. Activity of the selected IRQ always awakens the system. Default is IRQ3.
Options: N/A,3,4,5,7,9,10,11.
Suspend Mode
Enabled and after the set time of system inactivity , all devices except the CPU
will be shut off.
Options: Disabled,1,2,4,8,12,20,30,40 Min and 1 Hour.
HDD Power Down
When enabled and after the set time of system inactivity,the hard disk drive will be
powered down while all other devices remain active.
Options: Disabled, 1~15 Min.