User's Manual

mode, which allows you to run the

EISA Configuration Utility.

ERROR ENCOUNTERED INITIALIZING HARD DRIVE

Hard drive cannot be initialized. Be sure the adapter is installed correctly and all

cables are correctly and firmly attached. Also be sure the correct hard drive type is

selected in Setup.

ERROR INITIALIZING HARD DISK CONTROLLER

Cannot initialize controller. Make sure the cord is correctly and firmly installed in

the bus. Be sure the correct hard drive type is selected in Setup. Also check to see

if any jumper needs to be set correctly on the hard drive.

FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT

Cannot find or initialize the floppy drive controller. make sure the controller is

installed correctly and firmly. If there are no floppy drives installed, be sure the

Diskette Drive selection in Setup is set to NONE.

Invalid EISA Configuration

PLEASE RUN EISA CONFIGURATION UTILITY

The non-volatile memory containing EISA configuration information was

programmed incorrectly or has become corrupt. Re-run EISA configuration utility

to correctly program the memory.

NOTE: When this error appears, the

system will boot in ISA mode,

which allows you to run the EISA

Configuration Utility.

KEYBOARD ERROR OR NO KEYBOARD PRESENT

Cannot initialize the keyboard. Make sure the keyboard is attached correctly and

no keys are being pressed during the boot.

If you are purposely configuring the system without a keyboard, set the error halt

condition in Setup to HALT ON ALL, BUT KEYBOARD. This will cause the

BIOS to ignore the missing keyboard and continue the boot.