User Manual Part 1

Your remote may vary slightly from the one pictured here, but the basic functions should remain the same. Some features require your remote to
be programmed for operation and may not be available in all areas.
Indicator light: This button flashes red during the
programming sequences and when any key on the remote
is pressed.
POWER: Turns your TV on or off (it will not turn your DTA
off, the DTA is always on).
SET: Programs the remote control for your TV —
programming instructions and a complete list of TV
programming codes are available at comcast.com/
digitalnow and are included with your remote.
INFO: Displays the channel number and station call letters.
Keypad (0-9): Directly selects the channel you want to
view (i.e. 09 or 025).
ENTER: Directly tunes to a channel (i.e. 1-0-9 ENTER).
LAST: Recalls the last channel watched.
VOL +/VOL – : Turns the volume up or down.
CH +/CH – : Selects the next higher or lower channel.
MUTE: Turns the sound on your TV off or on.
LANG: Switches between different languages and audio
options available for that channel. If there is not an audio
option available, it may mute the channel — if you do not
hear sound, try pressing the MUTE button first to restore
sound. If that doesn’t work, try pressing the LANG button.
Using the Remote Control Signal Receiver
If you need or want to hide the DTA behind the TV, or if the
DTA will not reach the front of the TV, you can hide it by using
the Remote Control Signal Receiver. Plug the smaller end of
the Remote Control Signal Receiver into the “IR In” port on the
back of the DTA. Position the other end of the Remote Control
Signal Receiver where it can be seen from the front of the TV.
4
Using Your Remote Control
XDTA OOBE SIK 1010.indd 4 9/30/10 3:03 PM