User Manual Part 1

Coax Cable Connection with TV
Connect & Power Up
1. Find the coax cable that runs from the wall outlet to the back of your TV. Remove the end connected to
the back of your TV and connect it to the Cable In connection on the back of your DTA.
2. Connect the coax cable included in this kit from your DTA to the Cable In/RF In connection on the back
of your TV. Optional: Don’t like the DTA laying on top of your TV? Hide it using the Remote Control Signal
Receiver in your kit. Instructions are on the label.
Is your connection different? Information for alternate connections is available in this
section.
3. Plug the round end of the power cord into the Power input on the back of your DTA. Then plug the other
end into an electrical outlet.
4. Turn your TV on. Confirm that your TV is now on. Tune to Channel 3. Set the switch on the back of your
DTA to Channel 3.
Black screen? Switch both your TV and DTA to Channel 4.
5. Place the batteries in your Remote Control.
6. To program your Remote, locate the booklet that came with your Remote Control and follow the
instructions. You can do this now or later.
7. Do you have other kits to set up? If so, do that now.
Cable In Power
Back of DTA Set-Top Box
Back of TVCable Wall Outlet Electrical Outlet
Power CordCoax Cable
Coax Cable
To TV
Cable in/RF in
8
DTA Set-Top Box Connections
XDTA OOBE SIK 1010.indd 8 9/30/10 3:03 PM