User's Manual
Your DIRECTV HD/ HD DVR receiver has been designed to meet the highest standards of quality and security. It is important
that you observe the following precautions to ensure safe use of the equipment. Do not disassemble the receiver.
CAUTION! SHOCK HAZARD
Shows that there is a dangerous voltage within the receiver and you could receive an electric shock if you
manipulate it.
WARNING
To reduce the risk of fire or electric shock, you must not expose the receiver to rain or moisture, nor to
dripping or splashing. You should not place objects filled with liquids, such as vases or cups on the receiver.
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this receiver near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including
amplifiers) that produce heat.
9. Protect the power cord and plugs.
10. Protect the power cord from being walked on or pinched, particularly plugs, convenience receptacles, and
the point where they exit from the receiver.
11. Unplug this receiver during lightning storms or when unused for long periods of time.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the receiver. When a cart is used, use caution when moving the cart/receiver combination to avoid
injury from tip-over.
13. Warning: Use only the power supply that came with your unit.
14. If the power supply needs to be replaced, please contact DIRECTV Customer Service for an
authorized replacement.
15. Do not try to change the security design of the polarized or grounding type plug. A polarized plug has one
wider than the other leg. A polarized plug has two blades and a rounded tip. The wide blade and rounded tip
were placed for safety. If the plug supplied with the equipment does not fit the outlet, contact an electrician
to replace the obsolete outlet.
CARE FOR YOUR DIRECTV HD/ HD DVR
This receiver complies with Part 15 of the FCC Rules.
This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Responsible Party: DIRECTV
®
, Inc.
®
Satellite Receiver
LC61 & LH44
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
If you have problems with the receiver, contact DIRECTV Customer Service.
the user’s right to operate this equipment.
© 2015 DIRECTV. DIRECTV and DIRECTV Cyclon Design are trademarks of DIRECTV.
37484050
F. Additional Information
Some terms and additional information for this Software and third party software (including the text of licenses applicable
to any free software with open source code and other similar programs that may be included in Software) can be found in
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
equipment was verified for RF exposure and found to comply with Council Recommendation 1999/519/EC and FCC OET-65
RF exposure requirements.
be maintained between the antenna inside the equipment and the bodies of all persons exposed to the antenna in order to
result in theequipment exceeding the FCC RF exposure guidelines. This equipment must not be co-located or operated in
conjunction with anyother antenna or radio transmitter.
37484050 manual_legales_ENGLISH.indd 1-2 1/13/16 12:42 PM