Installation Guide
Table Of Contents
- Audience
- Typographic Conventions
- Overview
- Installation Tools
- Installing the Security System
- Step A: Setting up the Router
- Step B: Installing the Technicolor TouchScreen
- Step C: Ensure Your TouchScreen Configuration Information Is Correct
- Step D: Activating the System
- Step E: Adding Sensors to the Security System
- Step F: Testing the Alarm Functionality of the Security System
- Step G: Setting and Validating the Security Information
- Step H: Mounting the Sensors
- Step I: Configuring the TouchScreen
- Step J: Activating the Subscriber Portal
Installing the Security System
11
Step C: Ensure Your TouchScreen Configuration Information Is Correct
1. Ensure you have the following information from Customer Care:
Activation Code
Broadband Server IP
Cellular Server IP
Cellular APN
Deployment to which the TouchScreen, based on CPE ID, is applied in Inventory
(only if your system uses deployments).
2. On the TouchScreen, tap System Information.
The System Information screen is displayed.
Figure 3: Activation: System Information Screen
3. Tap directly on the Broadband Server value (the IP).
The Edit System Configuration Information screen is displayed.
4. Tap the Broadband Server IP, Cellular Server IP, and the Cellular APN value to change them. When
you tap them, a keyboard screen is displayed. Enter the new values and tap Done.
5. After all the values have been set, tap Next.
The System Information screen is displayed.
6. Tap Next.
The Welcome screen is displayed.