Installation Guide
Table Of Contents
- Audience
- Typographic Conventions
- Overview
- Installation Tools
- Installing the Security System
- Step A: Setting up the Router
- Step B: Installing the Technicolor TouchScreen
- Step C: Ensure Your TouchScreen Configuration Information Is Correct
- Step D: Activating the System
- Step E: Adding Sensors to the Security System
- Step F: Testing the Alarm Functionality of the Security System
- Step G: Setting and Validating the Security Information
- Step H: Mounting the Sensors
- Step I: Configuring the TouchScreen
- Step J: Activating the Subscriber Portal
Installing the Security System
19
Note: This only tests the TouchScreen’s ability to connect via broadband and cellular. It
does not determine whether the server is actually connected to the servers over
broadband and cellular.
3. When the connectivity test is successful for each, tap Next.
The TouchScreen checks for a newer firmware version to install.
Figure 16: Activation: Checking for Firmware Upgrade Screen
4. If an upgrade version is available, tap Upgrade Firmware.
If an upgrade is not available or after the upgrade is installed, tap Next.
The Enter Activation Code keypad is displayed.