Installation Guide

Installing the Security System
39
Step I: Configuring the TouchScreen
If necessary, perform the following operations:
Modify the Entry and Exit delay time periods (see page 48)
Modify the alarm transmission delay (see page 49)
Modify the “swinger shutdown” (see page 50)
Reset the TouchScreen to factory defaults (see page 50)
Note: This will cause the device to require activation again, which in turn will require that the
customer’s account be reset as well.
Check for a new firmware update (see page 52)
Manage the sensors/security zones (see Table 3: Sensor Operations on page 40)
Manage the cameras (see Table 4: Manage Camera Operations on page 40)
Manage key fobs and key pads (see Table 5: Manage Peripheral Operations on page 41)
Manage lights and thermostats (see Table 6: Manage Environmental Device Operations on page
41)
Technicians can also perform the following general activities that are also available to the customer.
Note: See the TouchScreen User Guide for information about these activities.
Manage the Quickarm settings.
Manage the way sensors are listed in TouchScreen reports and tools.
View and test the TouchScreen’s connectivity to the central monitoring stations.
Manage the keypad codes and secret word.
View the customer’s account information.
Manage your TouchScreen device sounds, screensaver, etc.
View technical information about the TouchScreen device.