Installation Guide Part 2
Table Of Contents
- Technician Operations
- Getting Started
- Testing Alarms
- Configuring the Entry/Exit Delay Periods
- Configuring the Alarm Transmission Delay
- Configuring the Swinger Shutdown Feature
- Resetting the TouchScreen to Factory Defaults
- Checking for New Firmware Updates for the TouchScreen
- Enabling Fire Alarm Verification
- Managing the Physical Devices in the Security System
- Managing Sensors & Zones
- Appendix A: General Concepts of the Security System
- Appendix B: TouchScreen Placement Options
- Appendix C: General Info for Sensor Placement
- Appendix D: Installer Quick Reference (SIA)
64
The following information is displayed about the sensor and security zone:
Sensor serial number and type (Door/Window, smoke detector, etc.)
Sensor signal strength detected by the TouchScreen
Security zone details such as its Display Icon and its function (Entry/Exit, Perimeter, etc.)
Resetting Sensors to Factory Default
When a sensor is originally removed from its packaging, it is already in factory default mode. When you
install the battery as described in the documentation, it will immediately begin searching for a
TouchScreen with which it can pair.
To reset a sensor that has already been added to a TouchScreen and place it in Search mode, delete it as
described in its included documentation.
In the rare event that you need to force default a sensor that is not paired to a nearby TouchScreen, see
the following pages in each case:
Door/window sensors—page 65
Glass break detector—page 65
Motion detector—page 66
Smoke detector—page 67
Home System Installation Guide