Installation Guide Part 2
Table Of Contents
- Technician Operations
- Getting Started
- Testing Alarms
- Configuring the Entry/Exit Delay Periods
- Configuring the Alarm Transmission Delay
- Configuring the Swinger Shutdown Feature
- Resetting the TouchScreen to Factory Defaults
- Checking for New Firmware Updates for the TouchScreen
- Enabling Fire Alarm Verification
- Managing the Physical Devices in the Security System
- Managing Sensors & Zones
- Appendix A: General Concepts of the Security System
- Appendix B: TouchScreen Placement Options
- Appendix C: General Info for Sensor Placement
- Appendix D: Installer Quick Reference (SIA)
80
To mount the TouchScreen to the wall:
.
1. Insert the A/C adapter into the
bracket.
See Table 2: A/C Power Supply Ratings
on page 1 for electrical ratings for the
A/C power supply.
2. Remove the center screw from the
wall outlet.
3. Plug the TouchScreen’s A/C
adapter into the TOP plug of the
wall outlet, and replace the center
screw through the bracket hole.
4. As shown in Cut a hole in the wall:
a. Cut a hole in the wall near an unswitched wall outlet (not
controlled by a light switch).
b. Drill a hole under the cut-out and work the A/C cable into
the hole and out of the cut-out/
Figure 39: Cut a hole in the
wall
5. Use the included screws to affix the wall mount to the wall over the cut-out (Affix the wall
mount).
Home System Installation Guide