Installation Guide Part 2
Table Of Contents
- Technician Operations
- Getting Started
- Testing Alarms
- Configuring the Entry/Exit Delay Periods
- Configuring the Alarm Transmission Delay
- Configuring the Swinger Shutdown Feature
- Resetting the TouchScreen to Factory Defaults
- Checking for New Firmware Updates for the TouchScreen
- Enabling Fire Alarm Verification
- Managing the Physical Devices in the Security System
- Managing Sensors & Zones
- Appendix A: General Concepts of the Security System
- Appendix B: TouchScreen Placement Options
- Appendix C: General Info for Sensor Placement
- Appendix D: Installer Quick Reference (SIA)
Technician Operations
51
To configure the swinger shutdown:
1.
From the Installer Settings Menu, tap Security ® Swinger Shutdown.
The Swinger Shutdown Settings screen is displayed.
2. Tap the right and left-pointing arrows to increase and decrease the number of swinger shutdown
trips (Maximum Trips).
Note: The number of trips cannot be less than 1 or exceed 6.
3. Tap Swinger Shutdown Enabled to disable this feature.
Tap Swinger Shutdown Disabled to enable this feature.
Resetting the TouchScreen to Factory Defaults
When an activated TouchScreen is reset to factory defaults, the customer’s account must also be reset
by Customer Care in order for it to be reactivated.
To reset the TouchScreen:
1. Ensure you have the premise passphrase for the account.
2.
From the Installer Settings Menu, tap Advanced Settings ® Reset to Factory Defaults.