User's Manual

Installing the Security System
47
Step H: Adding Lighting Devices to the Security System
Lighting devices control whether a light is turned on or off. The system can even manage dimmable
lights.
This action can be performed after wireless sensors are installed as described on Step F: Adding Sensors
to the Security System on page 28. You can skip this step and add the lighting devices later as described
on page 125.
IMPORTANT: If you need to update the firmware on any lighting device before adding it to the
security system, you must reset the lighting device to factory defaults before adding it
to the OpenHome Converge system. This is essential so that it can receive the
necessary changes to communicate with the TouchScreen.
The Install Zones and Home Devices screen is displayed.
1. Tap Lights.
The Locating Lighting Devices screen is displayed.
2. Tap Next.
3. Plug the lighting device into a wall socket. Secure it with a screw.