User's Manual
14 15TouchScreen TCA 300 Getting Started Guide – Installation TouchScreen TCA 300 Getting Started Guide – Installation
Sending An Emergency Alarm
You can manually trip an alarm in the event of an emergency by tapping the Panic button.
Emergency alarms are reported without an Entry delay or Alarm Transmission delay.
To manually trip an alarm:
Press the Panic button located in the
lower left corner of many screens.
1
2
The Panic Conrmation screen appears.
Press the button to send an
alarm for police assistance.
3
The TouchScreen will immediately issue a
continuous audible alarm and display an
Alarm in Progress screen which includes a
keypad for disarming the system if desired.
TouchScreen Installation and Maintenance
Installing the Technicolor TouchScreen
Remove the TouchScreen
from its packaging.
1
2
Remove the back plate from
the back of the TouchScreen
by pulling the center of the
bottom edge upward, then
sliding the top tabs out of
the slots.
Unwrap the 4 volt battery from
its packaging and insert the
end with the +/– contacts rst.
Snap the opposite end down
in the battery compartment to
complete battery installation.
3
BATTERY
The rechargeable battery that came WARNING:
with your TouchScreen is only available through
your service operator. If your battery needs to be
replaced, contact your service operator to arrange for
replacement.