User's Manual

TECHNICOLOR WORLDWIDE HEADQUARTERS

1, rue Jeanne d’Arc

92443 Issy-les-Moulineaux

France

www.technicolor.com

*DSL37228970*

DSL37228970

All tradenames referenced are service marks, trademarks,

or registered trademarks of their respective companies.

Specifications subject to change without notice.

DMS-SAF-20130624-0000 v1.0. Printed in China.

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

RF-exposure statement

When the product is equipped with a wireless interface, then it becomes a mobile or fixed mounted modular transmitter

and must have a separation distance of at least 20 cm (8 inches) between the antenna and the body of the user or

nearby persons. In practice, this means that the user or nearby persons must have a distance of at least 20 cm (8 inches)

from the modem and must not lean on the modem in case it is wall-mounted.

With a separation distance of 20 cm (8 inches) or more, the M(aximum) P(ermissible) E(xposure) limits are well above

the potential this module is capable to produce.

For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment. This device meets all the

other requirements specified in Part 15E, Section 15.407 of the FCC Rules.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Restricted frequency band

This product is equipped with an IEEE802.11b/IEEE802.11g/IEEE802.11n wireless transceiver and may only use

channels 1 to 11 (2412 to 2462 MHz) on U.S.A. territory.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1 This device may not cause harmful interference, and

2 This device must accept any interference received, including interference that may cause undesired

operation.