L A V P R O Safety Instructions and Regulatory Notices FO R A P Read this document prior to installation! *DSL36984940* 36984940 DMS-SAF-20110902-0002 v1.0. Printed in Vietnam. Copyright 2011 Technicolor. All rights reserved. All tradenames referenced are service marks, trademarks, or registered trademarks of their respective companies. Specifications subject to change without notice.
SAFETY INSTRUCTIONS AND REGULATORY NOTICES L BEFORE YOU START INSTALLATION OR USE OF THIS PRODUCT, CAREFULLY READ THESE INSTRUCTIONS When using this product, always follow the basic safety ! precautions to reduce the risk of fire, electric shock and injury to persons, including the following: Always install the product as described in the documentation that is included with your product. Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
Wireless In case this product is equipped with a wireless transceiver, it uses Direct Sequence Spread Spectrum (DSSS) /Orthogonal Frequency Division Modulation (OFDM) radio technology. As such it is designed to be interoperable with any other wireless DSSS/OFDM type product that: Complies with the IEEE802.11b/IEEE802.11g/IEEE802.11n Standard on Wireless LANs, as defined and approved by the Institute of Electrical and Electronics Engineers. Is Wi-Fi® CERTIFIED™ as defined by the Wi-Fi® Alliance.
Must not be mounted in a location exposed to direct or excessive solar and/or heat radiation. Must not be exposed to heat trap conditions and must not be subjected to water or condensation. Must be installed in a Pollution Degree 2 environment (Environment where there is no pollution or only dry, nonconductive pollution). Cleaning Unplug this product from the wall socket and computer before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
FO R A P P R O V A L The use of other types of supplies is prohibited. If you are not sure of the type of power supply needed, consult the product's user documentation or contact your local product dealer. USB The device is to be connected to an identified USB port complying with the requirements of a Limited Power Source. Accessibility The Direct Plug-in power supply, or the plug on the power supply cord serves as disconnect device.
Immediately disconnect the product if you notice it giving off a smell of burning or smoke. Under no circumstances must you open the equipment yourself; you run the risk of electrocution. Regulatory Information FO R A P P R O V A L You must install and use this device in strict accordance with the manufacturer's instructions as described in the user documentation that is included with your product.
FO R A P P R O V A L If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
North-America - Canada R O V A L Notification of Canadian Radio Frequency Interference Statement This Class B digital apparatus complies with Canadian ICES-003. NOTICE: This product meets the applicable Industry Canada technical specifications. Canada - Industry Canada (IC) In case this product is equipped with an IEEE802.11b/IEEE802.11g/ IEEE802.