EZCRG Owner’s Manual
A. Introduction The EZCRG is a self-contained entertainment center in your vehicle which makes your road trips enjoyable. This versatile floor console incorporates a high brightness 5” color TV and vertical eject Video Cassette Player, complete with a built-in speaker, a built-in foil antenna, headphone jacks, AV input jacks, AV output jacks and a universal remote control. Installed between the driver and passenger front seats, with a floor mounting plate available for most cars, vans and trucks.
7. In case anything falls into the cabinet, unplug the unit and have it checked by qualified personnel prior to further operation. 8. Only use the supplied power cord, and not use other power supplies even if they have the same current characteristics. 9. Always unplug the unit from the cigarette lighter socket of the vehicle if you do not intend to use it for an extended period of time.
NOTE: Whenever unit loading exceeds 3 Amperes, the unit power supply will overload and automatically disconnect the power supply from +12V DC vehicle power at the cigarette lighter jack. D.
a Figure 2 5
. Place 1 sealing washer (rubber side towards vehicle floor) and 1 large fender washer over each of the floor bolts and attach the floor nuts. In addition to the sealing washer, it may be desirable to place a small circle of silicon sealer around the hole under the vehicle before installing the washers and nut, to further prevent moisture from getting into the vehicle. 7. Tighten the floor nuts down securely.
DETAIL DC 12V INPUT DOOR DC 12V DOOR LATCH VIDEO L AUDIO R OUTPUT CABLE NOTCHES ANTENNA TERMINAL ANTENNA JACK NUT ANTENNA JACK OF FOIL DIPOLE Figure 3 7
H. Connecting an External Antenna (Refer to Figure 3) 1. Originally, the antenna jack of the built-in foil dipole has already been connected to the antenna terminal behind the door at the rear of the console. 2. In case of poor images with the foil dipole, loosen the nut around the antenna jack, unplug the antenna jack, and connect the coaxial cable of an external antenna to the antenna terminal. 3.
has accumulated inside of VCP. In this case, the VCP will not operate, and no VCP controls will be functional, except for the VCP power button on the remote control, until the unit dries out sufficiently and the word DEW disappears from the screen. When DEW mode has been activated, leave the VCP on to allow it to dry out completely. This will take approximately 1 hour. K.
1. TV POWER Button Press this button to switch the unit on or off . 2. Number Buttons (0-9) Press these buttons to make a direct TV channel selection. The channel number chosen will be displayed on the screen for about 4 seconds. 3. SKIP/SEARCH Button a. Press this button until SKIP MODE ON is displayed on the screen. Then use the channel up and down buttons’; the TV will stop only on the active TV channels. b. Press the skip search key until SKIP MODE OFF is displayed on the screen.
8. TV/VIDEO Button Press this button to select the TV mode and the AV mode in turn. When the power turns on, the unit will go to the mode last stored in memory. 9. MUTE Button Press this button to cut off all sound. Pressing this button again restores sound to the previously set level. Mute may also be canceled by pressing the volume up and down buttons. 10. CH Up Button Press this button to increment the TV channel number. 11. CH Down Button Press this buttons to decrement the TV channel number. 12.
O.
