EN
Main Connections (For UK only) EN CAUTION: For UK Only CONNECT THE MAIN LEAD INTO AC MAINS POWER SOCKET POWER SUPPLY 230V. It must not be connected to D.C. mains. Note: The mains lead of the set is fitted with a moulded plug. If the mains socket are not compatible or if for any reason the plug is removed please follow the directions below. The moulded plug cannot be rewired and if removed must be disposed of safely.
Safety Information TECHNICAL SPECIFICATIONS: Please respect the environment. Before throwing any batteries away, consult your distributor who may be able to take them back for specific recycling. Power supply AC 230V ~50Hz Clock backup:9V 6F22 Power consumption: 7W • Make sure that you keep your set away from water and high temperatures. • Do not use your system immediately after transporting it from a cold place to a warm place, as condensation may cause the system to malfunction.
Battery Back-Up Operation EN This clock radio is equipped with a memory holding system that can be powered with a 9V battery (not included). The power failure protection circuit will not operate unless battery is installed. When normal household power is interrupted, or AC line cord is unplugged, the battery will power the clock radio to keep track of time and alarm settings programmed into memory.
Operating the radio EN Memory BA Set Recall 1 SET 2 ON RAD OFF d M Fw ALAR P NA R NE TU ME TI IO Ca ew M AR cel AL n ND SLEEP Tuning the Stations Recalling the Stations 1. Press ON/BAND (located on the top of the radio) to turn on the radio. 2. Press ON/BAND to change the broadcast band (FM/MW for RR96M only, FM/ LW for RR96L), press OFF to turn off the radio. 3. Press or to select a station. 4.
Operating the clock EN Memory BA Set Recall 1 SET ON 2 d ALAR M Fw OFF P NA R NE TU ME TI RAD IO Ca ew M A R cel AL n ND SLEEP Setting Clock Time Setting the Wake Time Your digital clock operates on a 24-hour standard mechanism. 1. Press the SET button once to set ALARM 1 (1 will flash on display), twice to set ALARM 2 (2 will flash on display). 2. Press REV or FWD to set wake time. 3. When wake time is set.
Operating the Alarm Turning off Alarm Waking by Selected Source Programme You may be woken up by music Silence the alarm momentarily or . alarm 1. Select an AM or FM station. (refer to “Tuning the Stations”) 2. Set wake time (see above direction). 3. Press the ALARM 1 or ALARM 2 button to select waking up by music or alarm. An indicator is up next to the selected setting. 4. Adjust the volume by turning VOLUME. Note: When you turn off the alarm or the music by press- Press SNOOZE.
Other Functions EN Sleep Mode Nap Mode In sleep mode, the radio will turn off automatically. Simply: This function wakes you up after a short period of time. Simply: 1. Press SLEEP then the time display will exhibit 0:59 and the radio will turn on. 2. While holding SLEEP, press REV or FWD to set the sleep time. The time range is from 1 minute to 2 hours. 3. Release SLEEP and the current time will be shown again. The radio is turned on and you may select the station as usual.
Other Functions Snooze Alarm Operation Brightness control This operation allows extra sleep time after the alarm is on. The alarm will be off by pressing SNOOZE until the snooze period is over. Snooze function can be used repeatedly up to 2 hours. After this, the alarm will turn off until the next alarm conditions are met. Set the “quiet time” as follow: You can adjust the backlight by the BRIGHTNESS button, there are three modes you may select from: Seconds Time Display VOLUME OFF - Backlight off.
