User's Manual

ManualsBrandsTechnicolor ManualsDVD VCR ComboTechnicolor DVD Player + TV Set + VCR

Player Menus

DVD

The Display menu

1. Select the Display option in the main menu

using the and buttons and press button to

access the submenu.

2. Select one of the options using the and

buttons, and press button to access the various

options.

TV Aspect (DVD)

Select a format using the and buttons: 4:3 or 16:9 depending on the type of TV

connected to the player.

2. Press OK to confirm.

Display mode (DVD)

Note:This option is available only when the TV Aspect mode is set to 4:3.

1. Select a display mode using the and buttons:

Letterbox: displays a wide picture with horizontal bands on the upper and lower portions of

the screen,

Panscan: automatically displays wide pictures on the entire screen and cuts off portions

which do not fit.

2. Press OK to confirm.

Progressive Scan

Progressive Scan provides high quality pictures with less flickering.Turn on Progressive Scan if you

used the Component Video sockets of the player to connect a TV or monitor compatible with a

progressive scan signal.

1. Select On using the and buttons and press OK to confirm.

2. A confirmation screen appears. Cancel is highlighted by default. Use the button to high-

light Enter and press

OK to confirm.

Note: If your TV does not accept the Progressive Scan function, the picture will appear scrambled if you select

Progressive Scan on the DVD player.

Caution! Once Progressive Scan has been activated, an image will only be visible on a progressive scan TV or

monitor. If you activate Progressive Scan by mistake, you should follow below procedure to reset the unit:

Remove any disc from the unit and close the disc tray. Check that “No Disc” appears on the TV screen.Then

press the

STOP button and hold it for five seconds. The video output will be restored to the standard setting

and a picture will once again be visible on a conventional analog TV or monitor.

TV Output

Select the option corresponding to the TV connection type using the and buttons:

YPbPr: if your TV is connected to the COMPONENT/PROGRESSIVE SCAN VIDEO OUT

socket of the player,

RGB: if your TV is connected to the Scart socket of the player.

2. Press OK to confirm.

DISPLAY

TV Aspect

Widescreen

16 : 9

Display Mode

OffProgressive Scan

Move

Select

TV Output RGB

DTH6300E_EN 28/05/04 18:48 Page 32