CD Player - Portable Audio System User Manual

19
RQT6866
Basic operations
18
RQT6866
Basic operations
Cassette tapes
See page 39 for tape selection.
Preparation: Press [Í/I] to turn the unit on.
1 Press [< OPEN] on deck 1 or deck 2 and insert
the cassette.
Close the holder by hand.
2 Press [DOLBY NR] to select Dolby NR on
(“ÎNR” appears) or off.
3 Press [REV MODE] to select the reverse mode.
Each time you press the button:
b: One side is played.
d: Both sides are played.
f: Both sides are played 8 times each.
4 Press ["] (reverse side) or [!] (forward side).
Play begins and the indicator changes to green.
5 Adjust the volume.
To stop the tape
Press [∫].
[A] To change the deck to be used
Press [DECK 1/2] to select the deck you want to play.
To listen to 2 tapes consecutively
Insert a tape into each deck and select “f”. Both tapes will be played
8 times each.
ªB
Finding a place on a tape
To fast-forward and rewind
Press [6] or [5] while the tape is stopped.
To find the beginning of a track (TPS: Tape program sensor)
Press [6] or [5] during play.
Play resumes from the beginning.
Manufactured under license from Dolby Laboratories.
“Dolby” and the double-D symbol are trademarks of Dolby
Laboratories.
≥Each deck’s play direction is stored in the system’s memory.
≥You can fast-forward or rewind the tape while you are playing or recording
a tape in another deck.
Press [DECK 1/2] to switch to the deck not playing, and then press
[6] or [5]. After the above operation, be sure to press [DECK 1/2] to
reselect the deck playing.
Note
TPS may not operate correctly in the following situations:
If the interval between tracks is less than 4 seconds.
If there is noise between tracks.
If there are silent parts within tracks.
Dolby noise reduction
Dolby NR reduces “hissing” when playing tapes. It increases the high fre-
quency region when recording and then reduces it in playback. Use the
same system during playback and recording. This unit has Dolby B NR
which reduces noise to a third.
Prerecorded cassettes and equipment marked “ÎNR” use Dolby B NR.
Tape direction rewind fast-forward
!65
"56
A
B
1
2
3
4
5
DECK 1/2
DOLBY NR
REV MODE
< OPEN
76
114
∫
6
, 5
23
DECK 1/2
Í/I
5
VOLUME
UP
DOWN
-- dB
MIN
0 dB
MAX
NR
1
Î
NR Î
2
1
Î
NR
DECK 1 DECK 2
Forward side
Tape facing down
Tape direction
The radio: preset tuning
There are two methods of presetting stations.
Automatic presetting: The stations the tuner can receive are preset.
Manual presetting: You can select the stations to preset and the order
they are preset in.
There are 39 channels available for presetting.
ª
A
Automatic presetting
Do the following once each for FM and AM.
Preparation: Tune to the frequency presetting is to begin at (➡ page 17).
Hold down [SET].
Release the button when “AUTO MEMORY” appears.
The tuner presets all the stations it can receive into the channels in ascend-
ing order. FM stations are preset into channels 1 to 39, and AM stations are
preset into channels 21 to 39.
“SET OK” is shown when presetting is complete and the last station to be
preset is played.
“ERROR” is displayed if the tuner doesn’t receive any stations. Do preset-
ting manually if this happens (see below).
Note
AM stations replace any FM channels that were preset in channels 21
to 39.
ª
B
Manual presetting
Preset the stations one at a time.
1 Tune to the required station.
2 Press [SET].
3 Press [TUNING (X or W)] to select a channel.
4 Press [SET].
The station occupying a channel is erased if another station is preset in that
channel.
ª
C
Selecting channels
Preparation: Press [Í] to turn the unit on.
On the remote control
1 Press [TUNER/BAND].
2 Press the numbered buttons to select the
channel.
For channels 1 to 9 press the corresponding number.
For channels 10 or over press [S10/-/--], then the two digits.
e.g. To select channel 21: [S10/-/--]>[2]>[1]
3 Adjust the volume.
On the main unit
1 Select “PRESET” with [TUNING MODE].
2 Press [TUNING (X or W)] to select the channel.
A
B
C
1
2
3
MHz
SET
SET
SET
2
3
4
TUNER/
BAND
s
VOLUME
r
1
23
4
56
7
890
3
2, 4
1
3
2
DIGITAL
S.WOOFER
AV EFFECT
Í
SLEEP
CH SELECT
3D AI
PROGRAM
1
23
4
56
7
890
CANCEL
DISC
VCR/AUX/
6CH INPUT
TAPE/
DECK 1/2
SUPER
SOUND EQ
TUNER/
BAND
2/;
1∫
MUTING
45
s
VOLUME
r
EQ
PRO LOGIC
SUPER SRND
TEST
SETTUNING MODE
Í
TUNING
S10/-/--
CD
DISPLAY
X sALBUM W
S10/-/--
Preset channel