User Manual

Getting started
17
English
(17)
Armlift height
Make an adjustment according to your
cartridge if necessary.
Preparation

Put a record on the turntable.

Remove the stylus cover, taking care not
to damage the stylus, then release the arm
clamp.

Lift the cue lever and move the tone arm over
the record.
1
Check the armlift height (distance
between the stylus tip and record
surface).
If adjustment is needed, go to
step
2
.

The armlift height is factory-adjusted to
8 to 13 mm.
2
Return the tone arm to the arm
rest and fix it with the arm clamp.
Turn the adjustment screw.

Turning the screw clockwise lowers the
armlift.

Turning the screw anti-clockwise raises
the armlift.
1
2
Armlift
screw
Armlift
Arm clamp
Operation settings
Allows for LED color setting, reverse playback
setting, 78 rpm setting, torque setting and brake
setting.
①
Turn the unit off and pull out the power plug.
②
Adjust as desired by setting the switches with
a fine Phillips head screwdriver and the like.
ON
OFF
ON
ON LED REV 78 TQ1 TQ2 BK1 BK2
12345678
Allows you to select red or blue for the color of the
strobe light, speed select buttons, pitch range select
button and RESET LED lamp.
Switch no.: 1 (LED)
Red
OFF (Factory setting)
Blue ON
LED color setting
Allows you to disable or enable reverse playback. (

19)
Switch no.: 3 (REV)
REV disabled
OFF (Factory setting)
REV enabled ON
Reverse playback setting
Switch no.: 4 (78)
78 rpm disabled
OFF (Factory setting)
78 rpm enabled ON
Allows you to disable or enable 78 rpm. (

19)
78 rpm setting
Allows you to select from four levels of strength to
adjust the torque.
Switch no.: 5 (TQ1) Switch no.: 6 (TQ2)
High
①
ON ON
⇔
②
OFF ON
③
OFF (Factory setting) OFF (Factory setting)
Low
④
ON OFF
Torque setting
Switch no.: 7 (BK1) Switch no.: 8 (BK2)
High
①
OFF ON
⇔
②
OFF (Factory setting) OFF (Factory setting)
③
ON OFF
Low
④
ON ON
Allows you to select from four levels of brake strength
to stop the turntable after [START-STOP] is pressed.
Brake setting
Switch no.