Owner's Manual
Table Of Contents
- Operating Instructions
- Read first
- Table of contents
- Features
- Accessories
- Control reference guide
- Connections
- Operations
- Settings
- Sound adjustment
- Adjusting the volume of headphones "PHONES VOL”
- Using this unit exclusively for the playback of CDs "Pure Disc Playback”
- MQA decoding "MQA Decoding”
- Enabling the native playback for DSD signal "DSD Native”
- Disabling audio output "Digital Output”/“Analog Output”
- Setting the sampling frequency "D.Output fs”
- Setting the analogue audio output "A.Output Level”
- Adjusting the sound quality of analogue audio output "Filter”
- Setting the limitation ofheadphones output "PHONES VOL Limitation”
- Playing back CD more natural-sounding audio
- Direct mode
- Other settings
- Using the favourite function
- System control connection
- Sound adjustment
- Others
30
(Continued)
Wireless LAN connection
■
Preparation
Disconnect the AC mains lead.
Disconnect the LAN cable.
Place this unit as close to the wireless router as
possible.
Point up the antenna on the rear of this unit as
shown in the figure.
Connect the AC mains lead to this unit. (⇒ 27)
Note
• Do not perform the following:
Applying too much force to the antenna
Carrying this unit by holding the antenna
• After turning on this unit, it may take some time
until this unit is activated.
• After the network connection is set up,
“Updating” may be displayed and the firmware for
this unit may be updated.
After the update has finished successfully and
“Success” is displayed, turn this unit off and then
on.
• The setting will be cancelled after the set time
limit. In that case, try the setting again.
• “
” blinks while the network setting is not
complete, and blinking stops after the Wi-Fi
setting is complete.
• While “
” is blinking, the network setting
from “Google Home” may be available. Start the
“Google Home” app and follow the on-screen
instructions.
• To cancel this setting in the middle, press [
] or
turn the unit to standby mode.