Owner's Manual
Table Of Contents
- Operating Instructions
- Read first
- Table of contents
- Features
- Accessories
- Control reference guide
- Connections
- Operations
- Settings
- Sound adjustment
- Adjusting the volume of headphones "PHONES VOL”
- Using this unit exclusively for the playback of CDs "Pure Disc Playback”
- MQA decoding "MQA Decoding”
- Enabling the native playback for DSD signal "DSD Native”
- Disabling audio output "Digital Output”/“Analog Output”
- Setting the sampling frequency "D.Output fs”
- Setting the analogue audio output "A.Output Level”
- Adjusting the sound quality of analogue audio output "Filter”
- Setting the limitation ofheadphones output "PHONES VOL Limitation”
- Playing back CD more natural-sounding audio
- Direct mode
- Other settings
- Using the favourite function
- System control connection
- Sound adjustment
- Others
93
(Continued)
To restore all the settings to the
factory defaults
When the following situations occur, reset the
memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1 Press [NWP] while this unit is turned on.
2 Press [SETUP].
3 Press [
], [ ] repeatedly to select
“Initialization” and then press [OK].
4 Press [
], [ ] to select “Yes” and then
press [OK].
• A confirmation screen appears. Select “Yes” in
the following steps to restore all the settings to
defaults.
5 Press [ ], [ ] to select “Yes” and then
press [OK] again.