Owner's Manual
Table Of Contents
- Operating Instructions
- Read first
- Table of contents
- Features
- Accessories
- Control reference guide
- Connections
- Operations
- Settings
- Sound adjustment
- Adjusting the volume of headphones "PHONES VOL”
- Using this unit exclusively for the playback of CDs "Pure Disc Playback”
- MQA decoding "MQA Decoding”
- Enabling the native playback for DSD signal "DSD Native”
- Disabling audio output "Digital Output”/“Analog Output”
- Setting the sampling frequency "D.Output fs”
- Setting the analogue audio output "A.Output Level”
- Adjusting the sound quality of analogue audio output "Filter”
- Setting the limitation ofheadphones output "PHONES VOL Limitation”
- Playing back CD more natural-sounding audio
- Direct mode
- Other settings
- Using the favourite function
- System control connection
- Sound adjustment
- Others
95
(Continued)
Playback does not start.
• Depending on your environment or connected
devices, it may take some time.
• Check to see if the format of the file is supported.
For supported formats, refer to “File format”.
(⇒ 113)
The unit turns to standby mode automatically.
• Is the auto off function turned on? (⇒ 82)
• This unit may turn to standby mode simultaneously
with the connected device with the system control
function. (⇒ 89)
The settings are reset to the factory defaults.
• Updating the firmware may reset the settings.
The system control function is not working.
• Use the system connection cable supplied with the
connected device.
• Connect the system connection cable to the
system terminals (CONTROL). (⇒ 88)
• Connect Technics device supporting system
control function (Stereo Integrated Amplifier,
etc.) to this unit. For details, refer to the following
website.
www.technics.com/support/