Operating instructions

Playing back
Maintenance
English
(22)
English
(23)
Maintenance

WEEE symbol
Disposal of the product outside the EU
countries
This symbol is valid within the EU
only.
Contact a local governmental office
or your dealer to confirm a right
manner of disposal.
23

Moving the unit
Repackage the unit in the packaging it came
in. (

12)
Keep the packaging materials after taking out
the goods.
If you no longer have the packaging, do the
following:
z
Take off the turntable and turntable mat and
carefully wrap them.
z
Carefully wrap the main unit in a blanket or
paper.
Repackaging
22

Cleaning the main unit
Wipe the main unit and other components
with a dry soft cloth.
When dirt is heavy, wring a wet cloth tightly to
wipe the dirt, and then wipe it with a soft cloth.
z
Do not use solvents including benzene,
thinner, alcohol, kitchen detergent, a
chemical wiper, etc. This might cause the
exterior case to be deformed or the coating
to come off.
↑
Display dimmer setting
Display
Display dimmer when no operation
is performed for 20 seconds
Display OFF
Brightness is reduced by one level.
⇒
(No operation for further five seconds)
⇒
Brightness is reduced by two levels.
⇒
(No operation for further five seconds)
⇒
Off
Dimmer OFF
No dimming (Always on)
Dimmer 1
Brightness is reduced by one level.
Dimmer 2
Brightness is reduced by two levels.
Press [START·STOP] and then adjust the torque
(rotational force) at five levels to rotate the
turntable at a constant speed.
The display dimmer will be activated if the
control unit is not operated for 20 seconds.
There are four dimming patterns.
Adjusting the torque to rotate
the turntable at a constant speed
1
On the control unit, hold [RESET]
down and press [-] and [+]
simultaneously.
z
The torque setting is displayed.
2
Press [-] or [+] on the control unit
to make adjustment.
z
Select one of the five levels from
“TORQUE1” to “TORQUE5”.
Pressing the button increases or
decreases the value.
z
Use the table below as a guide.
z
The display returns to the original display
if no operation is performed within three
seconds.
↑
↑
33.33
33
TORQUE 1
TORQUE 5
[RESET][
ー
][
＋
]
1
On the control unit, hold [RESET]
down and press [DISPLAY].
z
The dimmer setting is displayed.
[+] [
- ]
2
Press [DISPLAY] on the control unit.
The setting changes each time [DISPLAY] is
pressed. (

See below.)
z
The display returns to the original display
if no operation is performed within three
seconds.
Note
z
The setting is saved. When the power is turned on
the next time, the setting when the power was
turned off last will be recovered.
Note
z
The setting is saved. When the power is turned on
the next time, the setting when the power was
turned off last will be recovered.
z
After setting, brightness is immediately adjusted
to the set value. The display is immediately turned
off if “Display OFF” is selected.
z
Operating a button (any button other than
the power button) on the control unit while
the dimmer is active returns the display to full
brightness.
↑
33.33
33
[RESET][DISPLAY]
[DISPLAY]
[DISPLAY]
[DISPLAY]
↑
↑
↑
Display OFF
Dimmer OFF
Dimmer 1
Dimmer 2
Operation and display of the control unit
(continued)
Display
Torque to rotate at a
constant speed
TORQUE5 Maximum (Initial setting)
TORQUE4
TORQUE3
TORQUE2
TORQUE1 Minimum
(Initial setting)
(Initial setting)