Operating instructions

Advanced operations / SSD
SSD
English
SSD
Advanced operations / SSD
You can replace the built-in SSD of this unit. Pull out the SSD tray from this unit to replace the SSD.
≥ For information on the handling of the SSD, refer to “SSD” (> 27).
≥ Before installing or removing the SSD, be sure to turn off this unit and pull out the mains plug from the
outlet. Not doing so may cause malfunctions.
≥ We recommend creating a backup of your important data to prevent its loss before replacing the SSD. (> 22)
Follow the steps below to replace the SSD.
お知らせお知らせ
Note
≥ Be careful not to touch the gold contacts on the SSD.







Remove all the screws (M3 k 4, Silver),
and take out the SSD.
≥ Use a cross-slot screwdriver to remove the
screws. Choose a cross-slot screwdriver that
matches the size of the screws.
≥
Do not tighten the screws with excessive
force. Doing so will strip their threads,
making it impossible to use the screws again.
Turn the storage tray over with the bottom
side facing up, and attach the new SSD.
≥ Be careful about the orientation of the SSD
and storage tray.
After pulling out the main plug from
the mains outlet, rotate the fixing screw
on the back of this unit to loosen it.
Hold both ends of the storage tray
to pull it out straight.
Storage tray (Top)
Storage tray
(Bottom)
Turn the storage tray over with the top side facing
up, and tighten the screws (
M3 k 4, Silver ).
≥ In the same way as in Step 3, hold the SSD
with one hand to prevent it from falling.
Insert the storage tray into this unit,
and tighten the fixing screw.
≥ After inserting the storage tray, tighten the
fixing screw firmly until the tray is secure.
SSD (label side)
Check the fixing screw position.
SSD (gold contacts)
Hold the SSD with one hand to prevent it from falling.
Format the SSD with “Technics Music
App“. (> 24)
For details, refer to the user guide for
“
Technics Music App “ .
Flip over the
tray.
SSD
23
(23)
ST-G30-SQT1222_mst.book 23 ページ ２０１６年２月２２日 月曜日 午後５時５２分