Operation Manual

Troubleshooting
≥ Insert the plugs of the cables to be connected all
the way in.
Playback does not start.
≥ Depending on your environment or connected
devices, it may take some time.
The settings are reset to the factory defaults.
≥ Updating the firmware may reset the settings.
The sound is interrupted.
≥ Depending on your environment, the audio may
be interrupted during playback. Check the
operating instructions of the connected device
and the connection to the device.
Recording does not start.
≥ Make sure that the disc is compatible with this
unit. (> 26)
≥ There is moisture on the lens. Wait for about an
hour and then try again.
≥ Recording to unfinalised CD-R and CD-RW discs is
not possible.
≥ WMA/MP3 is not supported. Refer to “CDs” (@ 26)
for information about the discs this unit can play
back.
Cannot connect to the network.
≥ Confirm the network connection and settings.
(> 16, 17)
≥ Make sure that the multicast function on the
wireless router is enabled.
≥ Make sure that the devices, smartphone and
tablet are connected to the same network as this
system.
≥ Turn off and on the network connection of the
smartphone, tablet or connected device, and
reconnect it to this unit.
Playback does not start.
The sound is interrupted.
≥ If the signal is interrupted, changing the location
and angle of the broadband router may improve
the signal reception of the connected device.
≥ If several wireless devices are simultaneously using
the same wireless network as this unit, try turning
off the other devices or reducing their wireless
network usage.
≥ If playback has stopped, check the playback status
on the smartphone, tablet or connected device.
This unit does not recognize the USB connection
correctly.
≥ Check to see if another device can detect your
USB device.
≥ If you connect USB HDD to this unit, use the USB
cable that is supplied with the HDD.
The USB device responds slowly.
≥ Large-capacity USB devices may respond slowly.
The SSD is not detected.
≥ Check to see if the SSD is attached
correctly. (> 23)
The STATUS indicator is flashing red.
≥ When you replaced the SSD, you might have
forgotten to format the new one. Before using a
new SSD, be sure to format it on this unit. (> 24)
Disc
Network
USB
SSD
25
ST-G30-SQT1219_mst.book 25 ページ ２０１６年１月２８日 木曜日 午後６時３０分