Quick start manual

Also see section 8.6 (DVB-S antenna setting) in your operating manual.

It is not possible to receive analogue TV via the cable or antenna!

4.2.3.1 Simultaneous operation with DVB-C/T antenna signals

Use the TechniSat DVB C/T switch to receive DVB-T signals, DVB-C and DVB-C cable

channels simultaneously (item no. 0000/3263). This switch automatically switches between

DVB-T reception and reception of DVB-C cable channels, thus preventing potentially con-

flicting frequency influences. For this purpose, connect the switch output as described

in section 4.2.3.

4.2.4 Operating with a rotating system

b For operation with a rotating system, connect the DiSEqC motor (Level 1.2) to LNB

input 1.

4.3 Connecting to a TV

d Connect the receiver (HDMI output) and TV (HDMI input) via an HDMI cable.

If your TV is equipped appropriately, it will automatically switch to the HDMI input when

the digital receiver is switched on.

Alternatively:

Connect the receiver (SCART socket) and TV (SCART socket) using a SCART cable.

If your TV is equipped appropriately, it will automatically switch to the AV and thus to

SAT operation when the digital receiver is switched on. It may be necessary to adjust

the signal type on your TV, see section 8.3.6 in your operating manual.

4.4 Hi-fi / surround sound amplifier

To achieve the best possible sound quality, you can connect your digital receiver to a hi-fi /

surround sound amplifier.

4.4.1 Digital

e If your amplifier is equipped with a suitable electrical or optical input, you should con-

nect the AUDIO OUT DIGITAL socket electrically or optically with the elec-

trical or optical input on your amplifier.

Depending on the signal provided by each broadcaster, sampling rates of 32, 44.1 and

48 kHz are available. In addition, where broadcast, the Dolby Digital signal is also

available on this output.

4.4.2 Analogue

e To do this, use a suitable cable to connect the cinch sockets Audio R and Audio L

on the digital receivers to an input on your hi-fi amplifier.

(e.g. CD or AUX; please note that the phono input is not suitable!)