Quick start manual

5.3 Accepting settings / Exiting menus and functions

In some menus and functions the changes made must be accepted manually in order to

save them permanently. If this does not happen, the function or the values that existed

before the change was made will be reset automatically on exiting the menu.

If an Accept field or the green function key with Accept is displayed in the bottom

line of the screen, you can see that the changes made must be saved manually to be

accepted.

> By highlighting Accept using the right/left arrow keys and confirming with the

OK button or by pressing the green function key Accept, the changes are saved

and you move back up to the next menu above.

Alternatively:

> Press the Return button.

A request appears asking whether the changes you made should be applied.

> Use the right/left arrow keys Yes or No and confirm your selection by pressing

the OK button.

Changes will now be saved or discarded according to your selection and you move

back up to the next menu level above.

Alternatively:

> Press the Menu button to leave the menu directly.

Settings that need to be saved manually will be reset in this case..

If the green function key is not displayed on the bottom line of the screen with

Accept, the changes are saved automatically on exiting the menu.

5.4 Changing a setting

You can create settings using the arrow selection method, the selection list, by

entering numbers and by using the virtual keyboard. The unit specifies the method

that can be used to change a highlighted setting. You can see this from the following dis-

played symbols:

Arrow selection method (section 5.4.1)

Arrows are shown on the left or right edge of the highlight.

Selection list (section 5.4.2)

The symbol is shown on the right edge of the highlight.

Entering numbers (section 5.4.3)

Virtual keyboard(section 5.4.4)

The symbol is shown on the right edge of the highlight.