Quick start manual

25
6 Initial installation
After you have read the safety instructions and connected the receiver as described in sec-
tion 4, you can then switch it on as described in section 5.
On initial installation of the receiver, the AutoInstall installation wizard is launched auto
-
matically. The installation wizard allows you to make the most important settings for your
digital receiver in the simplest way possible.
Each step of the installation explains which settings can be made.
> In the installation wizard start window, you can cancel the initial installation by pressing
red function button. The receiver then begins to run default pre-programming.
In the subsequent installation steps you can use the OK button to accept the setting
which you have selected and move on to the next installation step.
By pressing the Back button you can go back to the previous installation step. This
enables you to correct any wrong entries at any time.
The initial installation shown here simply serves as an example.
The exact process for the initial installation will depend on the settings you select. Therefore
please follow all instructions displayed on screen carefully.