Operation Manual

SELECT to conrm and then your radio will connect the selected station.

Update Stations List

Simply press SCAN, or, press MENU, then press  or  to ‘Full scan’, press SELECT

to conrm.

To Show the Signal Strength

During playing a DAB/DAB+ program, repeatedly press INFO until the LCD screen

display shows a signal bar with the strength of the current station.

The indicator on the signal bar shows the

minimum acceptable signal level.

Note:  Stations with signal strength below

the minimum signal level may not provide

a steady stream of audio.

Manual tune

Press 1. MENU  press  or  to < Manual tune >, press SELECT to conrm.

Press 2.  or  to browse channels and press SELECT to select the current

channel.

Note: If there is a multiplex corresponding to this channel and frequency, the display

will show a tuning meter with the signal strength and the multiplex name after a few

seconds.

Press 3. SELECT again to exit this order.

The way to Prune

To remove all currently inactive stations, please follow:

Press 1. MENU  press  or  to < Prune >, press SELECT to conrm.

Press 2.  or  to ‘Yes’, and then press SELECT to conrm.

DRC (Dynamic Range Control) value

You can set the compression level of stations to eliminate the differences in dynamic

range or sound level between radio stations.

Note: Set DRC to off indicates no compression;

Set DRC to low indicates little compression;

Set DRC to high shows maximum compression.