Operation Manual

4.4.1 Switching on the device

> Using the On/Standby buon on the device (1) or on the remote control (1) you can switch on the

device or switch it back to standby.

After switching on for the first time, you can launch the set-up wizard (Section 15.7). Here you can set

the time format, time zone, summertime adjustment and the date and time updating (via DAB+, FM,

Internet or no update) using the r/s PRESET, VOL+, VOL- and ENTER buttons on the remote control

(7, 9, 8, 26, 27) or by rotating and pressing SELECT/VOLUME knob on the device (5).

The device will then attempt to find a connection to a network. To do so, select the corresponding

WLAN network or LAN [cable] and enter the WLAN password if required using the r/s PRESET, VOL+,

VOL- and ENTER buttons on the remote control (7, 9, 8, 26, 27) or by rotating and pressing the SELECT/

VOLUME knob on the device (5).

4.4.2 Operating the device with the remote control

With the infrared remote control you can operate the most important device functions from the comfort of

your armchair. When operating the device with the remote control, please take into account the following

points:

> Point the remote control towards the front of the device.

> There must be a line of sight between the remote control and the radio.

> If the range of the remote control reduces, replace the battery with a new one.

The maximum range is approximately 4 metres from the front of the device.