Operation Manual

> If you wish to enter your WLAN password manually, or if your router does not support the WPS function,

select Skip WPS.

> Enter your WLAN password using the r/s PRESET, VOL+, VOL- and ENTER buttons on the remote

control (7, 9, 8, 26, 27) or by rotating and pressing the SELECT/VOLUME knob on the device (5) and

confirm with OK.

The entered password is now verified. This process is generally completed after a few seconds and the

WLAN connection can now be used.

15.2.2.2 Conﬁguration via the WPS function

This establishes a direct connection to the router. Selecting and/or entering a WLAN network (SSID) and

password is not required.

> Start the WPS function on your router as per the instruction manual.

> Then select PBC WLAN set-up to start the connection process.

Please observe the display overlays. The connection process is generally completed after a few seconds

and the WLAN connection can be used.

15.2.2.3 Manual conﬁguration

> Select Manual seings followed by Wireless to start manual conﬁguration.

> Now select whether you wish to automatically retrieve the IP address, gateway etc. on your router (DHCP

active) or to enter it manually (DHCP inactive).

Please take into account that automatic retrieval of the IP address, gateway, subnet mask etc. only

works if the DHCP function is activated in your router.

> In sequence, enter the IP address, subnet mask, gateway address, primary DNS and secondary DNS (if

required) using the r/s PRESET, VOL+, VOL- buttons.