Operation Manual

Manual Tune

1. Press MENU button, turn SELECT/TUNE knob to select Manual tune, and then press

SELECT/TUNE knob to confirm, the display will show the channel number and frequency.

2. Turn SELECT/TUNE knob to step among the channels and then press SELECT/TUNE knob

select the current channel.

→

# Note: If there is a multiplex corresponding to this channel and frequency, then the display will show a

tuning meter with the signal strength and the multiplex name after a few seconds.

3. To exit manual tune, directly press SELECT/TUNE knob again.

Prune Invalid

You may remove all unavailable stations from the station list.

1. Press MENU button, turn SELECT/TUNE knob to select Prune invalid, and then press

SELECT/TUNE knob to confirm.

2. Turn SELECT/TUNE knob to select ‘YES’, and then press SELECT/TUNE knob to confirm.

DRC (Dynamic Range Control) value

You can set the compression level of stations to eliminate the differences in dynamic range or

sound level between radio stations.

# Note: Set DRC to off indicates no compression; set DRC to low indicates little compression; set DRC

to high shows maximum compression.

1. Press MENU button, turn SELECT/TUNE knob to select DRC, and then press

SELECT/TUNE knob to confirm.

2. Turn SELECT/TUNE knob to select 'DRC high', 'DRC low' or 'DRC off', and then press

SELECT/TUNE knob to confirm.