GigaSwitch 9/8 Installation instructions
Contents 1 2 3 3.1 3.2 3.3 3.4 3.5 3.6 4 5 6 U s e s . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Sa fe t y n o t e s . . . . . . . . . . . . . . . . . . . . . . . .4 In s t a l l at i o n /m ou nt in g . . . . . . . . . . . . . . . . .4 General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Selecting the external unit/LNCs . . . . . . . . . . . . . . . . . . . . . . . . . .4 Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Basic unit (for a maximum of 8 parties) Art. No. 0000/3245 Cascade matrix (for a maximum of 8 parties) Art. No. 0000/3246 Mains power adapter Art. No.
2 Safety notes For your own protection, you should read the safety notes carefully before installing the equipment. The manufacturer accepts no liability for damage caused by inappropriate handling, or by ignoring the safety instructions. > Components should be mounted in a dry room, on a horizontal plane, consisting or flame-resistant materials. > When installing the equipment keep the electricity switched off. > Ensure the antenna installation is earthed.
Insulation should be stripped from the cable as follows: approx. 4mm 7mm crimp connector free wire 20mm 6 wire mesh silver foil 10 screw-on F connector 3.4 Antenna sockets The participants should be connected to the system via antenna sockets (SV 500 or SVT 500). This ensures that terrestrial programmes can be received without the need for an additional socket, and equipment connected in this way is protected from extraneous interference. 3.
Distribution of terrestrial programmes: > Ensure that the terrestrial signals fed into the system are of approximately equal strength. > A terrestrial pre-amplifer is not required. 5 Troubleshooting guide Problem Possible causes Solution No reception on any polarisation plane. Antenna position not correct Check the position of your antenna.
6 Technical Data Terrestrial 47 - 862 MHz, Satellite band: 950 - 2150 MHz 9/8 G Cascade 9/8 G + K Terr. Sat. Throughput damping 2 ... 3dB 2 ... 5dB Branch gain on 9/8K 1 ... 4dB -2 ... +3dB Branch gain on 9/8G Terr. Sat. -3 ... -1dB -2 ... +3dB -5 ... -4dB Decoupling receiver outputs 3) -4 ... -2dB 3) > 35dB Input levels recommended maximum Shielding Control Mains adapter Power, requirements of mains adapter max.
Your equipment is in accordance with CE, and complies with all relevant EU standards! Subject to change, not responsible for printing errors. Correct as at 02/04 TechniSat and GigaSwitch are registered trademarks of TechniSat Digital GmbH P.O.Box 560 D- 54541 Daun, Germany www.technisat.
