Installation guide

24
GB
Contents
1 Application
2 Safety notes
3 Components of the GigaSystem 17/8
4 Installation in buildings with one or two accommodation
units
4.1 Selecting the outdoor unit/LNB
4.2 Cables and connectors
4.3 Selecting antenna sockets
5 Installation of large-scale GigaSystem-distributions
5.1 Additional advice to LNB’s, cables and connectors
5.2 Planning
5.3 Installation
5.4 Calibration
5.5 Options for combinations with other TechniSat multi-
switch systems
5.6 Switching options with and without DiSEqC
6 Examples of installations
7 Trouble-shooting guide
8 Technical data
1 Application
The products of the GigaSystem 17/X serve to supply a large number of participants with up
to 16 satellite IF planes, plus the terrestrial signal.
Thus, you can distribute, for example:
> The full bands of 4 satellites (digital and analogue programs)
or
> 16 different satellite IF planes specifically selected.
For parties in the building who have no interest in foreign-language broadcasts, it is possible
to combine the GigaSystem 17/X cost-effectively under certain conditions with other
TechniSat multi-switch systems, see Paragraph 5.5.
The gain provided by the products remains within narrow tolerances, and is at levels relevant
in practice.
In the satellite range, the taps provide a slope-rectified coverage with gain at the upper band
limit.
The slope-rectified active terrestrial reception is ready for any future demands, and can distri-
bute DVB-T even in marginal reception areas.
Where required, DVB-C can also be fed in, and it is possible to configure a setup of the ter-
restrial range with 42 channels to conform the CENELEC.
GigaSystem_17_8_deu_engl_23112011_3.qxp 28.11.2011 09:34 Seite 24