Installation instructions

To install the outside unit proceed as follows:
Install the retaining bracket on the rotating prism
> Insert screw
6
through the slot in the rotating prism
5
so that the thread points away
from the rotating prism.
> Insert retaining bar
7
into screw
6
as shown in the illustration.
> In each case insert one flat washer
12
onto the two threaded ends of the screw
6
and screw on a nut 14, turning it several times.
Install the rotating prism on the reflector support
> Insert the rotating prism 5 onto reflector support 2 so that the hole in the rotating prism 5
and the top hole in the reflector support 2 are positioned on top of each other.
> Insert a screw 11 through a flat washer 12 and into the hole of the rotating prism 5.
> On the other side, place a flat washer 12 onto the screw 11, put a nut 14 onto the
threads and hand tighten.
> Turn the rotating prism 5 so that its lower corner is pointing at the elevation angle EL,
corresponding to your location.
> Insert a second screw 11 through the flat washer 13 and into the hole in the reflector
support 2 beneath the rotating prism 5.
> On the other side, place a flat washer 13 onto the screw 11, put a nut 14 onto the
threads and gently tighten.
Install the swivelling prism on the reflector support
> Hold the reflector 1 in front of reflector support 2, as shown in the illustration.
> Insert one nut 14 into each of the holes provided on reflector support 2.
> Now connect up the reflector 1 and reflector support 2 to each other using the 4
screws 8.
Fitting the LNB arm onto the reflector support
> Insert LNB arm 3 into the opening on the front of reflector support 2 and push it in
fully, so that it is free of play as it sits in the opening.
If necessary, tap LNB arm 3 gently from the front. If you do so, please ensure that
you do not bend LNB arm 3.
> Insert screw 10 through the hole and screw it into a nut 14.
Fitting the LNB onto the LNB arm
> Separate the two parts of the LNB holder 4 from each other and remove the two
connecting bond bridges.
> Hook the two parts of LNB holder 4 up to each other on the top side.
> Place the LNB into the opening of LNB holder 4 (the LNB connections must be
pointing downwards at the back) and fold them together.
> Insert a nut 14 into the LNB holder and screw these together using screw 9.
> Now insert LNB holder 4 onto LNB arm 3 and ensure that the former hooks into
LNB arm 3.
3
EN