MSDS

ManualsBrandsTechniSoil ManualsKitchenNanoPave 1-Gal. Low Sheen Concrete Sealer

TechniSoil SafeTy DaTa SheeT

TechniSoil NanoPave® Concrete Sealer

cr081913

TechniSoil Global Inc - NanoPave® Concrete Sealer - Safety Data Sheet

8. EXPOSURE CONTROLS /

PERSONAL PROTECTION

(CONTINUED)

RESPIRATORY PROTECTION: A respiratory protection program meeting OSHA 1910.134

and ANSI Z88.2 requirements or equivalent must be followed whenever workplace conditions

warrant a respirator’s use. None required if airborne concentrations are maintained below

the exposure limit listed in Exposure Limit Information. For airborne concentrations up to 10

times the exposure limit, wear a properly fitted NIOSH approved (or equivalent) half-mask,

air-purifying respirator. Air-purifying respirators should be equipped with NIOSH approved

(or equivalent) N95 filters. If oil mist is present, use R95 or P95 filters.

PROTECTIVE MEASURES: Facilities storing or utilizing this material should be equipped

with an eyewash facility.

ENGINEERING MEASURES: Use local exhaust ventilation with a minimum capture velocity of

100 ft/min. (0.5 m/sec.) at the point of vapor evolution. Refer to the current edition of Industri-

al Ventilation: A Manual of Recommended Practice published by the American Conference of

Governmental Industrial Hygienists for information on the design, installation, use, and main-

tenance of exhaust systems.

9. PHYSICAL AND

CHEMICAL PROPERTIES

APPEARANCE

For

m: liquid

Colour: white milky

Odor: acrylic

COMPONENT VALUE

6.0 - 8.0

Boiling point/boiling range 100 °C ( 212.00 °F) Water

Melting point/range 0 °C ( 32 °F)

Flash point Noncombustible

Lower explosion limit Not Applicable

Upper explosion limit Not Applicable

Vapour pressure 17.0 mmHg at 20 °C

(68.00 °F) Water

Relative vapour density <1.0 Water

Water solubility Miscible

Relative density 1.00 - 1.20

Viscosity, dynamic

80 - 400 mPa.s maximum

Evaporation rate <1.00 Water

Percent volatility

37 - 39 % Water

Volatile organic compounds

(VOC)

<= 5 g/L

NOTE: The physical data presented above are typical values and

should not be construed as a specification.

10. STABILITY & REACTIVITY Hazardous reactions

Materials to avoid

Polymerization

None known. Stable

There are no known materials which are

incompatible with this product.

Product will not undergo polymerization.