Installation Guide
®
Installation Instructions For:
G3® Commercial Surface
5660 Westside Road, Redding, CA 96001 USA Ph: 877-356-2250 Fax: 866-356-8880
www.TechniSoil.com E-mail: info@TechniSoil.com
I. Features & Benefits
TechniSoil G3® Commercial Surface (G3-CS) is a commercial
grade liquid polymer stabilizer for durable, dust-free surfaces
using decomposed granite (DG) or crushed stone materials.
This eco-friendly stabilizer bonds crushed aggregates and nes
to create walkways and patios. TechniSoil G3® Commercial
Surface lends efciency and innovation to natural surfacing
technology.
• Reduces tracking of loose materials
• Improves surface stability
• Easy to apply using standard equipment
• Minimizes dust, weeds, and erosion
• Low-maintenance
• Eco-friendly
II. Tool Recommendations:
• Shovel, pick, digging equipment
• Wheelbarrow
• Bow rake and/or grade rake
• Screed
• Shower head watering can or pressurized sprayer
• Masonry trowel
• Vibratory plate compactor
• Hand tamper
• Additional tools may be required for edge restraints
III. Material Recommendations:
G3-CS works best with 3/8” minus to 1/2” minus crushed stone
mixes, including but not limited to decomposed granite (DG),
crushed limestone, & granite screenings.
A linear gradation of angular crushed rocks to nes without
any dirt, clay, or sand is strongly recommended. Aggregates
with a moisture content of less than 3% are recommended.
IV. Coverage
G3-CS will cover 10ft²/gallon on average using two applications
per project.
• 1st application will require 20ft²/gallon to fully saturate
aggregate before compaction.
• 2nd application will require 30ft²/gallon as a topcoat.
• 3rd application requires 40ft²/gallon as a nal topcoat.
Recommended
Installation Rates:
Installation Phase: Coverage:
20 ft
2
per gallon
Pour-In
(Pre-compaction)
10 ft
2
per gallon
30 ft
2
per gallon
Topcoat
(Post-compaction)
40 ft
2
per gallon
Topcoat
(Post-compaction)
TYPICAL USES:COVERAGE up to:
• Light traffic paths & patios
• Landscaping
• Planter beds
• Erosion Control
10 Ft
2
Per Gallon
(See coverage rates in Section IV)
Install guidelines and application rates may vary.
If product does not match bottle image at left, please
contact manufacturer technical support at 877-356-2250.