Installation Guide

®
Installation Instructions For:
NanoPave
®
JSS
5660 Westside Road, Redding, CA 96001 USA Ph: 877-356-2250 Fax: [phone]
www.TechniSoil.com E-mail: [e-mail]
I. Features & Benefits
NanoPave® JSS (NP-JSS) is a revolutionary 2-in-1 joint
stabilizer and sealer product for use with pavers, natural
stone, and agstone. NP-JSS creates a strong, durable
bond in common sand or crushed stone jointing materials
for joints up to 4 inches. NP-JSS is a UV resistant,
VOC-free sealant that protects and helps maintain the
natural beauty of most paving surfaces.
• Industry leading, Advanced Formula JSS
• Water-based, VOC-free, nano-polymer technology
• Fast curing, lasting protection with ultra-high clarity
• Extreme temperature application range [40ºF - 90ºF]
• Suitable for application to dry or damp surfaces
• Formulated to penetrate and stabilize joints up to 4”
• Resistant to blushing, staining, & cracking
• Available in two breathable sheens
• Natural Look Finish - Ghost
• Enhanced Look Finish - Gloss
For premium aesthetic and durability, use UltraMix®
Designer Series Paver Joint Sand as recommended.
II. Tool Recommendations:
• Push broom / leaf blower
• Pressurized sprayer (25 - 40 psi)
• Foam rubber squeegee
• Vibratory plate compactor (A rubber sole
may be needed for some surfaces)
• Hand tamp and/or rubber mallet
III. Material Recommendations:
For joints ranging from 1/8” to 3/4” in width, use UltraMix®
Paver Joint Sand, standard masonry or playground sand.
For joints ranging from 3/4” up to 4”, use a crushed stone
mix or decomposed granite (DG) material preferably with a
gradation range of either 1/4” minus or 3/8” minus.
Avoid jointing materials that contain clay, dirt, or materials
that lack structural integrity. Screened aggregates that
may improve permeability will not stabilize well.
TYPICAL USES:COVERAGE up to:
• Pavers & Bricks
• Natural Stone
• Flagstone
100 Ft
2
Per Gallon
(See coverage rates in Section IV)
Install guidelines and application rates may vary. If
product does not match bottle image at left, please
contact manufacturer technical support at 877-356-2250.