Installation Guide

®
Installation Instructions For:
NanoPave
®
JSS
5660 Westside Road, Redding, CA 96001 USA Ph: 877-356-2250 Fax: [phone]
www.TechniSoil.com E-mail: [e-mail]
(Section VI continued)
Do not divide recommended application rates into multiple
coats. Always consult manufacturer coverage rate
guidelines or contact technical support at: 877-356-2250.
Use a foam rubber squeegee or equivalent to remove
excess or standing NP-JSS from the surface of the
pavement. Evenly distribute excess liquid into adjacent
joints.
Keep project area free from any moisture such as rain or
irrigation sprinklers, unnecessary foot trafc or otherwise
on treated areas until fully cured. (usually 12 - 48 hours in
optimal conditions).
Clean all tools immediately after use by simply rinsing
tools with water and a soft bristle brush.
VII. Storage
Store NP-JSS out of direct sunlight in areas with a
temperature range of 40º - 90º F.
VIII. Maintenance
Treated areas should withstand normal conditions for
24 - 48 months before a maintenance coat is needed.
• In high trafc settings and/or in inclement
weather conditions, an increased maintenance
schedule may be required.
If jointing material is in satisfactory condition and only
a sealer maintenance coat is needed, apply NP-JSS at
twice the original application rate.
To repair degradation that occurs in existing joints:
• Scarify exposed joint areas and ll with
additional sand or crushed stone mix.
• Use a padded hand tamp or rubber mallet to
completely ll joint as needed.
• Apply NP-JSS to the new material with a
pressurized sprayer and saturate until the joint
is milky white.
• Remove excess NP-JSS with a foam rubber
squeegee. In normal conditions, the repaired
area should be cured within 12 - 48 hours.
IX. Warranty
TechniSoil Global, Inc. warrants this product to be free
from defects. Where permitted by law, TechniSoil makes
no other warranties with respect to this product, express or
implied, including without limitation the implied warranties
of merchantability or tness for particular purpose. The
purchaser shall be responsible to orchestrate their own
tests to determine the suitability of this product for their
particular purpose. TechniSoil’s liability shall be limited in
all events to supplying sufcient product to re-treat the
specic areas to which product proven to be defective has
been applied. Acceptance and use of this product absolves
TechniSoil from any other liability, from any and all sources,
including liability for incidental, consequential or resultant
damages whether due to breach of warranty, negligence
or strict liability. This warranty may not be modied or
extended by representatives of TechniSoil, its distributors
or dealers, independent contractors, clients or end-users
of any kind.