NANOPAVE JSS 2.
Joint Material & Coverage Guidelines: NanoPave JSS covers up to 100 ft2/gal. Coverage rate is dependent on paver or stone porosity, joint width, depth and the type of jointing material used. NOTE: Avoid jointing materials that contain clay, dirt, or materials that lack structural integrity. Screened aggregates that may improve permeability will not stabilize well.
Features & Benefits: • • • • • • • • Advanced Formula JSS for hardscape walkways & patios. Color enhancing sealant commonly used on pavers, flagstone & bricks. Ideal for walkways, patios, pool decks, and other foot traffic areas. Formulated to penetrate and stabilize paver sand joints up to 3/4" wide and decomposed granite (DG) joints from 3/4” to 4” wide. Coverage rates up to 100 ft2/gallon depending on surface porosity and joint width.
Apply Jointing Material
A compactor can be used to disperse joint material Remove excess joint material using a leaf blower or broom
Apply NP - JSS Apply NP-JSS to hardscape surface using a low pressure sprayer (40 PSI). Concentrate primarily on the joints, and evenly apply over hardscape surface using the recommended coverage rate.
TIPS: Distribute NP-JSS with a foam rubber squeegee or sponge Keep project area free from foot traffic, and moisture such as rain or irrigation sprinklers until fully cured (usually 12 - 48 hours in optimal conditions). Clean all tools immediately after use by simply rinsing with water and a soft bristle brush.
Advanced Formula NanoPave JSS is a color enhancing 2-in-1 joint stabilizer and sealer liquid for walkways and patios built with pavers, natural stone, bricks, and flagstone. The cross-linking polymer stabilizes common jointing materials such as paver sand in joints ¾” or less, or decomposed granite (DG) in joints up to 4” wide. NanoPave JSS is available in two fast curing, ultra clear sheens, Natural Look, and Enhanced Finish.
