User's Manual

2-4
TDFM-600/6000 Transceiver Recommended Keypad Menu Defaults:
TDFM-600/6000
Series
Transceiver
ITEM
Portable
ITEM
Conventional
Operation
SmartNet
Operation
SMARTZONE
Operation
F1 Key Top Side
Button 1
Monitor Phone Phone
F2 Key Center Side
Button 2
Scan Scan Scan
F3 Key Bottom Side
Button 3
Talkaround/
Direct
Private Call Site
Display/Search
F4 Key Orange (Top)
Button
Emergency Emergency Emergency
MUP and
MDN keys
16-Position
Rotary Knob
Channel Select Channel Select Channel Select
ESW Key Two-Position
Concentric or
Ergo Switch
Blank (O)
Low Power (∅)
Blank (O)
Low Power (∅)
Blank (O)
Low Power (∅)
TSW Key Three-Position
Toggle Switch
Blank (A)
Scan (B)
Blank (C)
Blank (A)
Scan (B)
Blank (C)
Blank (A)
Scan (B)
Blank (C)
Note: It is possible to use Motorola’s Customer Programming Software (CPS™) to alter the default keypad
settings of the TDFM-600/6000 series radios. However if custom key settings are chosen it will not be
possible for Technisonic to help the Pilot or other Radio User through operational difficulties. These
questions will have to be referred to the Radio System Administrator responsible for customising the
settings. Technisonic recommends that the default key settings stay in place until all airframe
installation and operational issues have been overcome.
The TDFM-600/6000 series Transceivers are programmable by Motorola CPS™. The following settings may be
programmed for each Channel in a Conventional Radio:
Tx Frequency Zone
Tx PL/DPL Code Channel
Rx Frequency Name
Rx PL/DPL Code RX Signal Voice Type
Time-Out Timer TX Signal Voice Type
Scan List Network Access Code
Phone Tx Power
Smart PTT