User's Manual

3-1
SECTION 3
INSTALLATION INSTRUCTIONS
3.1 GENERAL
This section contains information and instructions for the correct installation of the TDFM-600/6000
Transceiver.
3.2 EQUIPMENT PACKING LOG
Unpack the equipment and check for any damage that may have occurred during transit. Save the original
shipping container for returns due to damage or warranty claims. Check that each item on the packing slip has
been shipped in the container.
3.3 INSTALLATION
The TDFM-600/6000 Transceiver is designed to be dzus mounted and should be installed in conjunction with
an IN-600 installation kit. See figure 3-1 for an outline drawing of the unit with dimensions to facilitate the
installation.
3.4 INSTALLATION KIT - CONTENTS
The IN-600 installation kit (P/N 019301-1) consists of:
1. One 25 pin Cannon D mating connector (female) complete with crimp pins and hood.
2. 3 BNC connectors.
3.5 ANTENNA INSTALLATION
The type and number of antennas depends on the model of transceiver being installed. The following is a list of
recommended antennas for the various RF modules:
VHF 136 to 176 MHz Comant part # CI-292
UHFLO 403 to 470 MHz Comant part # CI-275
UHFHI 450 to 512 MHz Comant part # CI-275
800 806 to 870 MHz Comant part # CI-306
The antenna should be mounted on the bottom of the aircraft whenever possible. Consult with instructions
provided with the antenna. Connect the RF cables to the back of the transceiver using the BNC connectors
provided in the installation kit.