User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-7300-3 Installation & Operating Instructions TiL 11RE436
2-7
2.16 CUSTOMER PROGRAMMING SOFTWARE (CPS™)
Programming the Bands 1 – 4 of the TDFM-7300-3 is usually done with the use of third party
programming software. Customer programming software or “CPS” must be supplied by Motorola.
To make any changes to the programming in the Type II radio, Motorola CPS™ software must be
used. There is no provision in the TYPE II modules to allow the user to change frequencies,
zones, PL tones etc. unless the Front Panel Programming (FPP) option has been purchased in
each band.
A Programming cable is required to connect the computer to the TDFM-7300-3. Bands 1 - 4 in
the TDFM-7300-3 are considered a XTS-5000 model III portable by the CPS™ software. To
program a band in the transceiver, it must be selected by pressing the BAND key before running
the CPS™. Follow the instructions supplied with the CPS™.
The CPS Programming software must be purchased from Motorola On Line (MOL).
For instructions on ordering Motorola parts and CPS software see TIB TIBFM 12-01 REV E.
This document is available on the Technisonic Web site at www.til.ca.
Follow the link for TDFM-7300-3 and click in the Link for “CPS Programming software/Cables
ordering Guide”. Refer to the section for TYPE II modules.
Programming cables for units with Type II modules
The TDFM-7300-3 transceiver that employs type II modules requires a Technisonic programming
cable, and Motorola “ASTRO 25 Portable CPS” Programming software, P/N RVN4181 (Latest
revision) It does not require a Smart Rib Box. For the Analog band Technisonic Multi TDP
software is required. Multi TDP is free and can be downloaded from the TIL website. Both
software packages use the same cables.
If encryption keys need to be loaded via a KVL-3000+, keyloader cable P/N 037348-1 may be
also be obtained from Technisonic. This keyloader cable will plug into the front mini DIN
connector of the TDFM-7300-3 transceiver.
The following cables can be purchased from Technisonic:
P/N 047365-1 TYPE II Download/Programming Cable that mates the 7300-3 front panel 8-
pin mini DIN to PC computer 9 pin serial port (See Figure 2.2).
P/N 037348-1 Encryption Keyload Cable that mates the 7300-3 front panel 8-pin Mini DIN
with Motorola KVL-3000+ Keyloader. Same P/N for type I or type II modules.
Refer to Figure 2.3.
These above cables are designed for use with the TDFM-7300-3 while it is installed in the aircraft.
An alternate cable can be used for programming if the radio is not installed and on the bench.
P/N 047366-1 TYPE II Download/Programming Cable that mates with the TDFM-7300-3 DB
25 pin connector on the back and to the PC computer 9 pin serial port. This
cable also provides power plugs to connect to a bench 28V power supply.