User's Manual

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-7300-3 Installation & Operating Instructions TiL 11RE436
2-14
The following is a list of TDFM-7300-3 analog band CTCSS/PL TONES:
TONE # PL (HZ) TONE # PL (HZ) TONE # PL (HZ)
0 CSQ 11 97.4 22 141.3
1 67.0 12 100.0 23 146.2
2 71.9 13 103.5 24 151.4
3 74.4 14 107.2 25 156.7
4 77.0 15 110.9 26 162.2
5 79.7 16 114.8 27 167.9
6 82.5 17 118.8 28 173.8
7 85.4 18 123.0 29 179.9
8 88.5 19 127.3 30 186.2
9 91.5 20 131.8 31 192.8
10 94.8 21 136.5 32 203.5
TONE # PL (HZ) TONE # PL (HZ) TONE # PL (HZ)
33 33.0 44 56.8 55 199.5
34 35.4 45 58.8 56 206.5
35 36.6 46 63.0 57 210.7
36 37.9 47 69.4 58 218.1
37 39.6 48 150.0 59 225.7
38 44.4 49 165.5 60 229.1
39 47.5 50 171.3 61 233.6
40 49.2 51 177.3 62 241.8
41 51.2 52 183.5 63 250.3
42 53.0 53 189.9 64 CSQ
43 54.9 54 196.6
TABLE 2.3 TDFM-7300-3 Analog Band CTCSS/PL Codes
2.20 FLASH UPGRADE MODE
NOTE: Flash upgrade mode only allows field upgrade for Bands 1 through 4. There is no flash
upgrade for Band 5.
On occasion it may be required to flash upgrade one or more of the RF modules in the radio to
change or add new features. This can be done using CPS software and a Motorola flash upgrade
kit. The transceiver must be put into flash upgrade mode by turning on the radio while holding the
HOME key. Select the band to be upgraded by pressing the band key. Press the RESET soft key.
Wait until the display shows Flash upgrade mode again. The selected module is now ready to
accept a flash upgrade. Follow the instruction supplied with the flash upgrade kit for configuring
and using the CPS. When flash upgrade is completed, press the EXIT soft key to reboot the
7300-3 to normal operation. For detailed instructions refer to TIL document 106517 “FLASH
UPGRADE PROCEDURE FOR TDFM 6000/7000/7300 SERIES RADIOS”.