Operation Manual

ManualsBrandsTechno line ManualsAir ConditioningKL4912

KL4912 Desktop weather station

Instruction Manual

Introduction

This weather station comes with backlight, indoor and outdoor temperature &

humidity display, and alarm clock with calendar.

Fig. 1 Front view Fig. 2 Back view

1. “MODE” button

2. “MAX/MIN” button

3. “

▲

CHANNEL” button

4. “

▼/°

F / RCC” button

5. “SNOOZE / LIGHT” button

6. Battery compartment

7. A/C in-jack

Getting started:

Installing A/C adapter – highly recommended

1. Remove all “AAA” batteries before plugging in A/D D/C adapter. See instructions

below.

2. Plug in A/C D/C adapter at A/C input jack (7) (see figure 2).

Batteries installation

1. Open battery compartment (6) on the back of the unit. (see figure 2)

2. Install / replace with 3x “AAA” size batteries in the compartment. It is

recommended that only alkaline batteries are used.

3. Replace the battery compartment (6) on the back of the unit.

4. A short beep will be heard to confirm proper installation of batteries.

Batteries safety warnings:

Summary of content (6 pages)

PAGE 1
KL4912 Desktop weather station Instruction Manual Introduction This weather station comes with backlight, indoor and outdoor temperature & humidity display, and alarm clock with calendar. Fig. 1 Front view 1. 2. 3. 4. 5. 6. 7. Fig. 2 Back view “MODE” button “MAX/MIN” button “▲ CHANNEL” button “▼/°C/°F / RCC” button “SNOOZE / LIGHT” button Battery compartment A/C in-jack Getting started: Installing A/C adapter – highly recommended 1. Remove all “AAA” batteries before plugging in A/D D/C adapter.
PAGE 2
1. 2. 3. 4. 5. 6. 7. Please read all instructions carefully before use. Install batteries correctly by matching the polarities (+/-). Always replace a complete set of batteries. Never mix used and new batteries. Remove exhausted batteries immediately. Remove batteries when not in use. Do not recharge and do not dispose of batteries in fire as the batteries may explode. 8. Ensure batteries are stored away from metal objects as contact may cause a short circuit. 9.
PAGE 3
Press “▲ CHANNEL” button (3) or “▼/°C/°F / RCC” button (4) to change the AM/PM or 12-hour clock setting. Press “MODE” button (1) again. Press “▲ CHANNEL” button (3) or “▼/°C/°F / RCC” button (4) to change the TIME ZONE setting. Press “MODE” button (1) again. Press “▲ CHANNEL” button (3) or “▼/°C/°F / RCC” button (4) to change the hour setting. Press “MODE” button (1) again. Press “▲ CHANNEL” button (3) or “▼/°C/°F / RCC” button (4) to change the minute setting.
PAGE 4
This weather station is equipped with outdoor temperature and humidity display. The weather station is capable of synchronizing with up to 3 external sensors. 1 external is included with this weather station. Contact your local authorized re-sellers to purchase additional external sensors. RST 1 RTS 3 RTS 4 RTS 2 Fig. 4 Back View RTS 1. RTS 2. RTS 3. RTS 4. Fig. 5 Back view - open Hang hole Battery compartment screws “RESET” button “Channel 1 2 3” switch Batteries installation 1.
PAGE 5
limited to hurricane, typhoon, and cyclones seasons. Do not place the unit in area of high winds. 3. Do not place the remote temperature sensor more than 30 meters (98 feet) from the receiving weather station. The remote temperature sensor is most effective if there are no obstruction and interference between the remote temperature sensor and the weather station. The remote temperature sensor might have to closer than 30 meters if the weather station is not able to receive any signals.
PAGE 6
• • • • Keep unit away from small children. The unit or parts of the unit might be a choking hazard. Never attempt to recharge the batteries in any other methods. Dispose the unit legally. Recycle when possible. Specifications Indoor temperature range: 0℃ to 50℃ ( 32°F to 122°F) Relative humidity range: 20% - 95% Power: 3 x AAA-size 1.