WS6825 - INSTRUCTION MANUAL LED WEATHER STATION WITH RADIO CONTROLLED CLOCK AND ALARM
Words in the figure: ENGLISH Front view ALARM ON TIME RCC INDICATOR INDOOR TEMPERATURE OUTDOOR TMEPERATURE WEATHER FORECAST Back view SNOOZE/DIMMER UP/RF SET ALARM DOWN/WAVE RESET AC/DC ADAPTOR DC SOCKET INSERT AC/DC ADAPTOR JACK STAND HOLE INSERT 1 x CR2032 BATTERY INSIDE THE BATTERY COMPARTMENT BATTERY DOOR HANGER HOLE OUTDOOR TEMPERATURE SENSOR LED RESET STAND CHANNEL 1 CHANNEL 2 CHANNEL 3 INSERT 2 x AAA BATTERIES OTHER LANGUAGE
ENVIRONMENTAL RECEPTION EFFECTS The weather station obtains the accurate time with wireless technology. Same as all wireless devices, the reception is maybe affected by the following circumstances: Long transmitting distance Nearby mountains and valleys Among tall buildings Near freeway, railway, airports, high voltage cable etc.
During reception, the signal strength may move from 1 bar to 2 bars to 3 bars. This is normal since the clock is detecting DCF signal and other signals in the air at the same time. Press the SET button will return to the time display with icon flashing. Successful reception or failed reception Icon becomes static on (stop blinking) when reception is successful. Icon disappears when reception is failed.
TIME SETTING 1. 2. 3. 4. Press and hold the SET button for 2 seconds, hour digits flash. Press the or the button to set the hours. Then pressthe SET button again, the minute digits flash. Press the or the button to set the minutes. Then press the SET button again, display shows 05 and flash. Press the or the button to set snooze duration from 5 minutes to 60 minutes. Then press the SET button again, display shows 00 and flash.
If you lose the outdoor temperature When the outdoor temperature digits show “--“, the wireless transmission is either interrupted or lost. Press and hold the button of the station, then press the RESET button located on the back of the outdoor transmitter. If you continue to lose the outdoor temperature display, try placing the transmitter in a different location until you have smooth transmission of temperature data.