User's Manual
Table Of Contents
- Chapter 1 Introduction of Tablet
- 1. Basic Operation
- 1).Charging& Battery Management
- It is suggested to fully charge the battery before use. The best state for the battery is after charged and discharged two or three times.Charging Process: connect the power adapter one end to your tablet, and plug the other end of power adapter to th...
- 2). Turn on/off
- (2).Turn off: Press & hold the power switch for around
- 3 seconds and the system will popup out power off option, tap on it to turn the tablet off.
- 2. Standby & Unlock
- 1)、Automatic Standby: there are no any operation to the device under the system default or in set time state, device will shutdown screen, and enter standby state
- automatically.
- 4. Custom Homepage Interface
- 5. G-sensor
- Chapter 3 Basic Settings
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
z Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
IMPORTANT NOTE:
Federal Communication Commission (FCC) Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in
ANSI/IEEE C95.1-1999 and had been tested in accordance with the measurement methods
and procedures specified in OET Bulletin 65 Supplement C.