User's Guide

REGULATORY INFORMATION

Technology Solutions UK Ltd hereby declares that this radio equipment is in compliance with Directives 2014/53/

EU and 2011/65/EU.

The reader operates using the speciﬁed frequencies up to the maximum output powers as in the table below:

Radio Frequency of operation Maximum Output Power

Bluetooth

2.4 GHz 12 dBm

UHF RFID 865 MHz - 868 MHz 28 dBm

MARKING AND EUROPEAN ECONOMIC AREA (EEA)

INFORMATION TO THE USER – FCC

Federal Communication Commission Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own expense.

FCC Caution:

● Any changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate this equipment.

● This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Radiation Exposure Statement:

The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and is

safe for intended operation as described in this manual. Further RF exposure reduction can be achieved if the

product is kept as far as possible from the user body or the device is set to a lower output power if such function is

available.