Video Doorbell V5 User Manual 1. The Basics Mounting Bracket amnniem_1 1. PIR Motion Sensor 5. Microphone 9. AC 8Y--24V Power Interface 13. Power Contact Base 2. infrared LED x6 6. Push Button 10. Reset Button 14. Mounting Screw Holes *4 3. Light Sensor 7. LED Indicator 11. Mira USB Port (Battery Charging) 15. Wire Terminals 4.166° HD Camera 2 Speaker 12.
In The Box video Doorbell VS. Martingale | 5 Mourning Scr i Ha 3 Hardwired Security Sen 5 Archers User Marl & fi : snatcher Onions) | HUED, | chime optioned 2. Hard wiring Connect the wires coming out of your wall to the screws on the back of your doorbell Please make sure the red wire Gan only canister to the left screw and the thee wire can only connect 1o the right screw.
Or Battery Power Charging Time: 14 hours using 1A USB charger (not included) (via the doorbell micro USB port) Please fully charge the 18650 batteries before use The batteries can last around 3 to 4 months between recharges with normal use (5-min events a day). This also depends on events captured Live View: Up to 30 hours Lots of events: If your device is capturing an excessive number of events every day, you might need to recharge your battery saner.
3. Set up your video doorbell in the Topee APP Download the To See app. The To See app will walk you Open the Topee app injurious Open the battery cover and through' setting up and remotely controlling your Doorbell cellphone. Tap“+~ then tap pull out the insulation tabs. Search for "To See” on the Apple app store or Google Play.
Tap*The Red Light is Flashing ies Tap Enter the Configuration Interface”.
Find the name of your WiFi network ahd tap on it. Enter Your WiFi password, then tap“Next” a Ga Elmer Sheree Enter your device administrator password, then tap Next" Enter your device name and tap “Complete” Tap the doorbell Live View.
5. Install Your Video Doorbell On The Wall NOTICE: Mark 4 drill holes and use a bit te drill holes in your wall Be sure ta urn on push notifications on your phone. and insert the anchors: Secure your doorbell on the wall 1. Navigate to Settings -> Notifications -> ON ‘with 4 mounting screws and 1 security screw. 2. List of apps that support push notifications will appear 3. Tap the To See and choose your captions 4. App Live View Interface Ibadan 2. Share 3. Settings 4, Battery 5. Volume 6. Playback 7.
6. Troubleshooting Q: How to RESET yourselves? A: Press and hold the RESET Button for 6 seconds; Q: How share you video doorbell with your family? A: 1. Open the To See App: # From the home page, tap the doorbell Live View. + Tap the"Share icon” in the tap right corner = Enter the device administrator password, the tap “Confirm" + # Enter the new user's Nickname, then tap “Confirm” You will see a QR code. 2. Open the To See App on the new user's cellphone # From the home page, tap +" in the top right comer.
2. Getting Started Set up your chime with the video doorbell Before the setup process, be sure your video doorbell has connected to your phone and plug in your chime Press the forward or back button to cycle through 52 different tunes and select a tune. Press the daorbellbuttan, the chime emits two Ding sounds = © Press and hold the volume button for 5 seconds until the bite indicator is ON.
